How much does it cost to replace a well in Florida?

Put simply, drilling a 300-foot well in Fl typically costs $25-$65 per foot or $3,750 to $15,000 on average for a complete water system.


How much does it cost to dig a new well in Florida?

Well drilling costs $15 to $25 per foot for the drilling process only. Installing a complete well water system costs $25 to $65 per foot, irrigation wells run $50 to $100 per foot, and geothermal wells are $15 to $40 per foot.

How long does a well last in Florida?

A water well professional can help you schedule further inspection, maintenance and testing to keep your new well system operating at peak capacity. A properly constructed and maintained well can provide 20+ years of safe drinking water for you and your family.


How deep is a residential well in Florida?

Florida Well Depth Requirements

Florida wells can go as deep as 1000 feet, but most in our area of North Central Florida run 100 to 400 feet because the aquifer is closer to the ground's surface. For most homeowners, a 3-4 inch diameter well outfitted with a pump works best.

Do you need a permit to dig a well in Florida?

A permit is required prior to the construction of all new wells and the repair, modification or abandonment of an existing well regardless of the size. The permit ensures that wells are built by licensed water well contractors and conform to water well construction standards within the State of Florida.


Drilling a Well | Process Explained & Cost Breakdown



Do wells dry up in Florida?

Because Florida is blessed with a plentiful supply of water, the answer to the question “Do Water Wells Run Dry?” is yes, although not frequently.

Does a well ever need to be replaced?

A well's lifespan is considered to be roughly 20 to 30 years. Over time, yield may decline because of sediment or mineral scale build-up. For some homeowners, however, a well can last many years beyond this lifespan.

How deep should a well be for drinking water in Florida?

How deep should your well be? Where you are in the district determines how deep your well must be to get water. For example, throughout central Florida, the Floridan aquifer is 100 to 200 feet beneath the land's surface.


How far down is water table in Florida?

Aquifer facts

The Floridan aquifer is found beneath all of Florida and portions of Alabama, Georgia and South Carolina, and extends into the Gulf of Mexico and the Atlantic Ocean. The Floridan aquifer averages 1,000 feet thick, and freshwater can extend to a depth of 2,000 feet below land surface.

How often should a well be replaced?

Once your well has reached its serviceable life (usually at least 20 years), have a licensed or certified water well driller and pump installer decommission the existing well and construct a new well. For more information visit “Finding a Contractor ” (National Ground Water Association).

Does a new well add value to your home?

Wells and Property Values. A functional well on a property can increase the home's value. The buyer is spared the expense of constructing the well in the first place, but benefits from the lack of water bill. Unless a well no longer works or is contaminated, there should be an overall increase in the property value.


How often does a well need to be replaced?

With proper well maintenance, your well pump can last, on average of 8 to 15 years, though many homeowners report their pumps lasting far longer, often between 20 and 30 years! However, owning a home with a well means that you'll likely have to replace your well pump at some point, but how will you know when it's time?

Is it legal to drill my own well in Florida?

All wells must be constructed by a licensed water well contractor. The only exception to this law is for a water well two (2) inches or less in diameter constructed by an individual for his/ her own private use on his/her owned or leased property as specified in Section 373.326(2), Florida Statutes.

How deep should a well be for drinking water?

The quality of your water depends on several factors including geology and water levels. In order to allow for maximum ground filtration to remove impurities, your well depth should be at least 100 feet. As a general rule, the deeper you drill, it's more likely that there will be minerals present.


How long does it take to drill a well in Florida?

Depending on drilling conditions, well installation can take 1–2 days.

How far does Septic have to be from well in Florida?

Contaminants can travel long distances in some soils. Therefore, drinking water wells should be located at least 75 feet from any part of a septic tank system. With certain exceptions, septic tanks and drain fields must be located at least 75 feet away from the high water line of ponds, rivers and lakes.

Do deeper wells mean better water?

Well depth can affect both the quality and quantity of water pumped from a well. As shown in figure 2, the quality of water in a well is influenced by the land use activities that take place in its recharge area. As for quantity, a well that is not deep enough to reach the water table will yield no water at all.


How long does a well pump last in Florida?

When properly installed, new pumps last up to 15 years. You'll also spend less on maintenance and be able to ensure you have a steady flow of water whenever you need it. No matter how handy you are, pulling and replacing a pump at your Tampa, FL home is a job that's best left to the professionals.

What are the signs that you need a new well?

Keep reading to find out more!
  • You May Need a Well Repair if You Have No Water. ...
  • There's a Loss in Water Pressure. ...
  • You Hear Loud Noises. ...
  • There Is Air “Spitting” From Your Faucet. ...
  • Your Well Water Is Dirty or Smells Bad. ...
  • The Pump Continues to Run.


What is the average life of a well?

What is the Average Life Span of a Well? he average life span of an oil or natural gas well is 20 to 30 years. However, new technologies are being developed to find ways to extend the life span. The life span of a well is based on the active years the well is in production.


How long does it take to put in a new well?

Depending on the conditions of the weather, ground and water depth as well as drilling conditions, it typically takes 1 to 3 days, sometimes longer, to drill a well. You should keep in mind that these factors vary from one site to another and from one well to another.

Do wells refill when raining?

While your well is a 6” hole in the ground, it is not directly replenished by rainfall, as you might expect a cistern to function. The rainfall that seeps into the ground on your property moves through the soil at a rate of only 10 feet per year.

Can you drink well water in Florida?

The majority of these wells produce water that tastes good and is free of harmful contaminants. Unfortunately, certain chemicals and bacteria that may cause disease have been found in some wells in Florida.


Why does Florida well water smell?

Certain “sulfur bacteria” in the groundwater, in the well water itself, or in the plumbing system can create this gas that smells bad. Chemical reactions inside water heaters can also produce sulfur bacteria. In rare cases, pollution can cause the gas to form. Sulfur bacteria are not harmful.